GroutPro UniSeal 20 Litre

GroutPro UniSeal

GroutPro UniSeal is a professional quality topical sealer designed to give the surface it is applied to a hard wearing protective high gloss coating. This coating protects the surface from the harsh effects of abrasive wear, spillages and weathering. GroutPro UniSeal is water based, virtually odourless, non- flammable and low VOC. It is also highly UV resistant making it suitable for indoor and outdoor use.

DIRECTIONS

1. The surface should be clean, unpainted and free from oil, grease, dirt and flaking material. All dust and debris must be removed by thorough vacuuming.
2. Clean the floor with an approved high alkaline detergent (pH 12.5 or above). Rinse thoroughly.
3. Any existing sealer should be stripped and removed with an appropriate sealer stripper.
4. New concrete should be allowed to cure for 28 days prior to application of UniSeal.
5. Very smooth concrete should be acid etched with GroutPro Anti-Slip to improve bond strength.
6. Floors must be TOTALLY DRY before application of UniSeal. This is important to ensure good adhesion and clarity. If the floor is damp, the film may dry with a milky, hazy appearance. The sealer may also fail to bond to the floor correctly.
7. Apply UniSeal using a brush, short nap roller or paint pad. Give the floor a generous coating but avoid puddling. The porosity of the floor will determine the actual coverage.
8. Try to avoid generating bubbles. If bubbles are left they must be broken before the sealer dries by dragging a clean soft brush or broom across the surface.
9. IMPORTANT. After the first coat is touch-dry, it must be left for a further 45 to 60 minutes before the next coat is applied. This ensures the correct bond strength of the base coat. 1 hour between coats. The floor MUST be tack free before re-coating. Minimum 3 coats internally, 4 externally.
11. Allow the area to dry for 3 to 4 hours before allowing light traffic (no shoes) or overnight (12 hours) before normal traffic.

DO NOT APPLY TO COLD FLOORS (10◦ or less)

DO NOT DILUTE THIS PRODUCT.
Clean the applicators with hot or cold water before the sealer dries.

SAMPLE TESTING

Always test first according to directions to determine desired results.

Note: Old sealers must be removed prior to testing.

FIRST AID

Eye Contact – In case of contact, flush with plenty of water for 15 minutes.

Ingestion –  drink a glass of water and seek medical advice. Do not induce vomiting.

Use generally accepted safety precautions while operating polishers or buffing machines. User assumes all responsibilities and risk.

For full instructions refer to the GroutPro UniSeal fact sheet & application guides at groutpro.com.au.

DANGER

KEEP OUT OF REACH OF CHILDREN

Statement of Hazardous Nature This product is classified as: Not classified as hazardous according to the criteria of SWA. Not a Dangerous Good according to Australian Dangerous Goods (ADG) Code, IATA or IMDG/IMSBC criteria. SUSMP Classification: None allocated. ADG Classification: None allocated. Not a Dangerous Good according to Australian Dangerous Goods (ADG) Code, IATA or IMDG/IMSBC criteria. UN Number: None allocated Signal word: NONE. Composition/Ingredients Polymer dispersion (aqueous) 30-60% Polyethylene <10% Resin <10% Glycol ether <10% Ammonium hydroxide <0.2% Balance other non hazardous ingredients including water